Users Guide

Parameters
max-value Enter the maximum number of FIP snooping sessions with an ENode that are
supported on the switch. The range is 1 to 64.
Defaults 32
Command Modes
● CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The maximum number of supported FIP snooping sessions that you configure is displayed in the running
configuration (if it is not the default value) and in show fip-snooping config output.
If you configure a smaller number of supported sessions than was previously configured, all current FIP
snooping sessions continue and a warning message is displayed. If a greater number of sessions are active
with an ENode, additional sessions are not allowed as long as the total number is greater than the newly
configured limit.
When the maximum number of FIP snooping sessions for an ENode are already active on the switch, a log
message is recorded if the ENode tries to log in to initiate another session.
fip-snooping port-mode fcf
Configure the port for bridge-to-FCF links.
Syntax
fip-snooping port-mode fcf
To disable the bridge-to-FCF link on a port, use the no fip-snooping port-mode fcf command.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the Z9500 and S6000-ON.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
Usage
Information
The maximum number of FCFs supported per FIP snooping-enabled VLAN is four.
fip-snooping port-mode fcoe-trusted
Configure the port for bridge-to-bridge links. It is not recommended to use this command because multi-hopt FSB is not
supported.
Syntax
fip-snooping port-mode fcoe-trusted
To remove the bridge-to-bridge link configuration from the port, use the no fip-snooping port-
mode fcoe-trusted command.
Command Modes INTERFACE
FIP Snooping 557