Users Guide

Version Description

9.8(0.0P2) Introduced on the S3048-ON.

9.5(0.0) Introduced on the Z9500.

9.4(0.0) Introduced on the S4810, S4820T, S5000, and S6000.

Usage

Information

Activate the VRF application on a device using the feature vrf command in CONFIGURATION mode.

The no feature vrf command is not supported on any platform.

show feature

Verify the status of software applications, such as VRF, that are activated and running on a device.

Syntax

show feature

Command Modes

EXEC

EXEC Privilege

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

Version Description

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.4(0.0) Introduced on the S4810, S4820T, and S6000.

Usage

Information

You can activate VRF application on a device by using the feature vrf command in CONFIGURATION

mode. The no feature vrf command is not supported on any of the platforms.

Example

Dell# show feature

Feature State

------------------------------

VRF Enabled

Dell#

Command Modes

To navigate and launch various CLI modes, use specific commands. Navigation to these modes is described in the following

sections.

BGP ADDRESS-FAMILY Mode

To enable or configure IPv4 for BGP, use BGP ADDRESS-FAMILY mode. For more information, see Border Gateway Protocol

IPv4 (BGPv4).

To enter BGP ADDRESS-FAMILY mode:

1. Verify that you are logged in to ROUTER BGP mode.

2. Enter the address-family command.

3. Enter the protocol type:

● For IPv4, enter the ipv4 multicast command. The prompt changes to include conf-router_bgp_af for IPv4.

CLI Basics