Users Guide

The configuration of bandwidth allocation and strict-queue scheduling is not supported at the same time
for a priority group. If you configure both, the configured bandwidth allocation is ignored for priority-
group traffic when you apply the output policy on an interface.
If you enable this command for a QoS ETS output policy, no bandwidth percentage is assigned to the
policy.
Related
Commands
● qos-policy-output ets — configure the ETS bandwidth allocation.
● bandwidth-percentage — bandwidth percentage allocated to priority traffic in port queues.
show interface ets
Displays the ETS configuration applied to egress traffic on an interface, including priority groups with priorities and bandwidth
allocation.
Syntax
show interface port-type slot/port[] ets {summary | detail}
Parameters
port-type slot/
port[] ets
Enter the port-type slot and port ETS information.
{summary |
detail}
Enter the keyword summary for a summary list of results or enter the keyword
detail for a full list of results.
NOTE: This command also enables you to view information corresponding to a range of ports.
However, for Open Networking (ON) platforms the notation for specifying port range in the
command is different from how you specify in non-ON platforms.
● For non-ON platforms, you can specify multiple ports as slot/port-range. For example, if you
want to display information corresponding to all ports between 1 and 4, specify the port range as
show interfaces interface-type 1/1 - 4.
● For ON platforms, you can specify multiple ports as slot/port/[subport] - slot/port/
[subport]. For example, if you want to display information corresponding to all ports between 1 and
4, specify the port range as show interfaces interface-type 1/1/1 - 1/1/4.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.9(0.0) Added support to display the interface configurations corresponding to a range of
ports.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.2) Down status messages added.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Example
(Summary)
Dell# show interface te 1/3 ets de
Interface TenGigabitEthernet 1/3
Max Supported TC Groups is 4
Number of Traffic Classes is 8
Data Center Bridging (DCB) 483