Users Guide

Usage
Information
Use the stop jumpstart command on a switch running BMP 2.0 if the switch enters a loop while
reloading in jumpstart mode; loop occurs when the switch is continuously trying to contact a DHCP server
and a DHCP server is not found. The stop jumpstart command stops the switch from connecting to
the DHCP server. After you use the stop jumpstart command, the next default reload type is a
normal reload. This is indicated in the show reload-type command.
Related
Commands
reload type — configures the reload mode as normal or jumpstart (BMP).
454 Bare Metal Provisioning (BMP)