Users Guide

show reload-type
Display the reload type currently configured on the system.
Syntax
show reload-type
Defaults none
Command Modes EXEC Privilege
Command
History
To execute the post-configuration script after applying the startup configuration,
Version 9.0.2.0 Introduced on the S6000.
Version 9.2(0.0) Updated output example to include auto-save and retry-count parameters.
Version 9.1(0.0) Updated reload type parameters.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.4 Introduced on the Z9000.
Version 8.3.10.0 Introduced for the S4810.
Usage
Information
Check the currently configured auto-configuration mode (BMP or Normal reload) on a switch running
BMP 3.0 using the show reload-type command.
The show bootvar or show system brief commands can also be used to display the current
reload mode for BMP 3.0. The commands include the path of the Dell Networking OS image file retrieved
from a DHCP server.
Example
Dell#show reload-type
Reload-Type : normal-reload [Next boot :bmp]
Auto-Save : enable
Config-Download : enable
Dhcp-Timeout : 30
Retry-Count : 4
Related
Commands
reload type — Configure the reload mode as Normal or BMP.
stop jump-start
To prevent an infinite loop, stop the switch from reloading in BMP mode.
Syntax
stop jumpstart
NOTE: This command has been deprecated. It has been replaced by the stop bmp command.
Defaults none
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.1(0.0) Deprecated command. Replaced by the stop bmp command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.4 Introduced on the Z9000.
Version 8.3.10.1 Introduced for the S4810.
Bare Metal Provisioning (BMP) 453