Users Guide

Usage
Information
Dell Networking OS software resolves the network address configured by the network command with
the routes in the main routing table to ensure that the networks are reachable using non-BGP routes and
non-default routes.
Related
Commands
redistribute – redistributes routes into the BGP.
redistribute
Redistribute routes into BGP.
C-Series, E-Series TeraScale, S-Series
Syntax
redistribute [connected | static] [route-map map-name]
To disable redistribution, use the no redistribution [connected | static] [route-map
map-name] command.
Parameters
connected Enter the keyword connected to redistribute routes from physically connected
interfaces.
static
Enter the keyword static to redistribute manually configured routes.
These routes are treated as incomplete routes.
route-map map-
name
(OPTIONAL) Enter the keyword route-map followed by the name of an
established route map.
Only the following ROUTE-MAP mode commands are supported:
● match ip address
● set community
● set local-preference
● set metric
● set next-hop
● set origin
●
set weight
If the route map is not configured, the default is deny (to drop all routes).
Defaults Not configured.
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command
History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
Usage
Information
If you do not configure the default-metric command, in addition to the redistribute command,
or there is no route map to set the metric, the metric for redistributed static and connected is “0”.
To redistribute the default route (0.0.0.0/0), configure the neighbor default-originate
command.
Related
Commands
neighbor default-originate – injects the default route.
Border Gateway Protocol 429