Users Guide

Command
History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series. Added 4-byte support.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
neighbor route-map
Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group.
C-Series, E-Series TeraScale, S-Series
Syntax
neighbor {ip-address | peer-group-name} route-map map-name {in | out}
To remove the route map, use the no neighbor {ip-address | peer-group-name} route-
map map-name {in | out} command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
map-name
Enter the name of an established route map.
If the Route map is not configured, the default is deny (to drop all routes).
in Enter the keyword in to filter inbound routes.
out Enter the keyword out to filter outbound routes.
Defaults Not configured.
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command
History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
Usage
Information
When you apply a route map to outbound routes, only routes that match at least one section of the route
map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the characteristics in the Route
map used in this command. If you identify a peer by IP address, the Route map overwrites either the
inbound or outbound policies on that peer.
neighbor route-reflector-client
Configure a neighbor as a member of a route reflector cluster.
C-Series, E-Series TeraScale, S-Series
Syntax
neighbor {ip-address | peer-group-name} route-reflector-client
To indicate that the neighbor is not a route reflector client or to delete a route reflector configuration, use
the no neighbor ip-address | peer-group-name route-reflector-client command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
Border Gateway Protocol 427