Users Guide

E-Series software sends a message. The range is 1 to 100 percent. The default is
75.
warning-only (OPTIONAL) Enter the keyword warning-only to set the router to send a log
message when the maximum value is reached. If this parameter is not set, the
router stops peering when the maximum number of prefixes is reached.
Defaults threshold = 75
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command
History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
neighbor next-hop-self
Allows you to configure the router as the next hop for a BGP neighbor.
C-Series, E-Series TeraScale, S-Series
Syntax
neighbor {ip-address | peer-group-name} next-hop-self
To return to the default setting, use the no neighbor {ip-address | peer-group-name}
next-hop-self command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
Defaults Disabled.
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command
History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
neighbor remove-private-as
Remove private AS numbers from the AS-PATH of outgoing updates.
C-Series, E-Series TeraScale, S-Series
Syntax
neighbor {ip-address | peer-group-name} remove-private-as
To return to the default, use the no neighbor {ip-address | peer-group-name} remove-
private-as command.
Parameters
ip-address Enter the IP address of the neighbor to remove the private AS numbers.
peer-group-name Enter the name of the peer group to remove the private AS numbers.
Defaults Disabled (that is, private AS numbers are not removed).
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
426 Border Gateway Protocol