Users Guide

peer-group-name Enter the name of the peer group to set the default route of all routers in that peer
group.
route-map map-
name
(OPTIONAL) Enter the keyword route-map followed by the name of a configured
route map.
Defaults Not configured.
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command
History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
neighbor distribute-list
Distribute BGP information using an established prefix list.
Syntax
neighbor [ip-address | peer-group-name] distribute-list prefix-list-name
[in | out]
To delete a neighbor distribution list, use the no neighbor [ip-address | peer-group-name]
distribute-list prefix-list-name [in | out] command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to apply the distribute list filter to all routers in
the peer group.
prefix-list-name
Enter the name of an established prefix list.
If the prefix list is not configured, the default is permit (to allow all routes).
in Enter the keyword in to distribute only inbound traffic.
out Enter the keyword out to distribute only outbound traffic.
Defaults Not configured.
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.6.1.0 Introduced IPv6 MGBP on the E-Series.
Usage
Information
Other BGP filtering commands include: neighbor filter-list, ip as-path access-list, and
neighbor route-map.
Related
Commands
ip as-path access-list – configures the IP AS-Path ACL.
neighbor filter-list – assigns a AS-PATH list to a neighbor or peer group.
neighbor route-map – assigns a route map to a neighbor or peer group.
424 Border Gateway Protocol