Users Guide
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.4.1.0 Introduced.
Usage
Information
This command enables soft-reconfiguration for the BGP neighbor specified. BGP stores all the updates
the neighbor receives but does not reset the peer-session.
You cannot set this configuration for a peer that is associated with a peer group. Similarly, you cannot
associate a peer to a peer group if that peer is already configured with these settings.
CAUTION: Inbound update storage is a memory-intensive operation. The entire BGP update
database from the neighbor is stored in memory regardless of the inbound policy results
applied on the neighbor.
NOTE: This command is supported in BGP Router Configuration mode for IPv4 Unicast address only.
Related
Commands
● show ip bgp neighbors — display routes received by a neighbor.
neighbor subnet
Enable passive peering so that the members of the peer group are dynamic.
Syntax
neighbor peer-group-name subnet subnet-number mask
To remove passive peering, use the no neighbor peer-group-name subnet subnet-number
mask command.
Parameters
subnet-number
Enter a subnet number in dotted decimal format (A.B.C.D.) as the allowable range
of addresses included in the Peer group.
To allow all addresses, enter 0.0.0.0/0.
mask
Enter a prefix mask in / prefix-length format (/x).
Defaults Not configured.
Command Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
376 Border Gateway Protocol