Users Guide

Version 7.2.1.0 Introduced.
Usage
Information
When you enable soft-reconfiguration for a neighbor and you execute the clear ip bgp soft in
command, the update database stored in the router is replayed and updates are re-evaluated. With this
command, the replay and update process is triggered only if route-refresh request is not negotiated with
the peer. If the request is indeed negotiated (after executing the clear ip bgp soft in command),
BGP sends a route-refresh request to the neighbor and receives all of the peer’s updates.
Related
Commands
clear ip bgp — activates inbound policies without resetting the BGP TCP session.
capture bgp-pdu max-buffer-size
Set the size of the BGP packet capture buffer. This buffer size pertains to both IPv4 and IPv6 addresses.
Syntax
capture bgp-pdu max-buffer-size 100-102400000
Parameters
100-102400000 Enter a size for the capture buffer.
Defaults 40960000 bytes.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Introduced
Related
Commands
capture bgp-pdu neighbor — enables capture of an IPv4 BGP neighbor packet.
show capture bgp-pdu neighbor — displays BGP packet capture information for an IPv6 address.
capture bgp-pdu neighbor
Enable capture of an IPv4 BGP neighbor packet.
Syntax
capture bgp-pdu neighbor ipv4-address direction {both | rx | tx}
To disable capture of the IPv4 BGP neighbor packet, use the no capture bgp-pdu neighbor
ipv4-address command.
Parameters
ipv4-address Enter the IPv4 address of the target BGP neighbor.
direction {both |
rx | tx}
Enter the keyword direction and a direction — either rx for inbound, tx for
outbound, or both.
Defaults Not configured.
338 Border Gateway Protocol