Users Guide

Version Description
9.10(0.0) Introduced on the S6100–ON, S6000, S6000–ON, S5000, S4810, S4820T, S3048–
ON, S4048–ON, MXL, FN IOM, C9010, S3100, and Z9100-ON.
Related
Commands
● show running-config — views the current configuration.
● privilege level (CONFIGURATION mode) — controls access to the command modes within the switch.
ignore startup config
Ignore the system startup configuration.
S5000
Syntax
ignore startup config
Command Modes BOOT USER
Command
History
Version 9.0(1.3) Introduced on the S5000.
interface management ethernet ip address
Set the IP address and mask of the management port.
S5000
Syntax
interface management ethernet ip address ip-address/mask
Command Modes BOOT USER
Command
History
Version 9.0(1.3) Introduced on the S5000.
interface management port config
Set the speed or transmission mode of the management port.
S5000
Syntax
interface management port config {10m | 100m | 1000m | auto-negotiate | no
auto-negotiate | full-duplex | half-duplex}
Parameters
10m Set the management port to operate at 10 Mbps.
100m Set the management port to operate at 100 Mbps.
1000m Set the management port to operate at 1000 Mbps.
auto-negotiate Set the management port to auto-negotiate its speed with a peer device.
no auto-
negotiate
Remove auto-negotiation from the management port and reset it to the default
values (transmit at 100 Mbps in full-duplex mode).
full-duplex Set the management port to transmit in full-duplex mode.
176 Boot User Mode