Users Guide

clear the management port ip address and mask
reload
reload entire chassis
show boot blc
show the boot loop counter value
show boot selection
display rom bootstrap bootflash partition
show bootflash
summary display of boot flash information
show bootvar
summary display of operating system boot parameters
show default-gateway
display the default gateway ip address
show interface management ethernet
display the management port ip address and mask
-(93%)-Use <CR>to continue, q to stop:
show interface management port config
show the management port boot characteristics
syntax help
show syntax information
ignore enable password
Ignore the enabled password.
S5000
Syntax
ignore enable password
Command Modes BOOT USER
Command
History
Version 9.0(1.3) Introduced on the S5000.
enable sha256-password
Configure SHA-256 based password for the enable command.
Syntax
enable sha256-password [level level] [encryption-type] password
To delete a password, use the no enable sha256-password [encryption-type] password
[level level] command.
Parameters
sha256-password Enter the keyword sha256-password then the encryption-type or the
password.
level level (OPTIONAL) Enter the keyword level then a number as the level of access. The
range is from 1 to 15.
encryption-type
(OPTIONAL) Enter the number 8 or 0 as the encryption type.
Enter 8 to enter the sha256–based hashed password.
password Enter a text string, up to 32 characters long, as the clear text password.
Defaults No password is configured. level = 15.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Boot User Mode 175