Users Guide

Command
History
Version 9.0(1.3) Introduced on the S5000.
help
Display the Help menu.
S5000
Syntax
help
Command Modes BOOT USER
Command
History
Version 9.0(1.3) Introduced on the S5000.
Example
BOOT_USER # help
***** Dell Force10 Boot Interface Help Information *****
Current access level: USER LEVEL
Use "syntax help" for more information on syntax.
Available command list (30 commands total):
boot change [primary|secondary|default]
change operating system boot parameters
boot messages disable
turn off netbsd boot messages
boot messages enable
turn on netbsd boot messages
boot show net config retries
show number of retries for network boot config failure
boot write net config retries <int>
write number of retries for network boot config failure
boot zero [primary|secondary|default]
zero operating system boot parameters
default-gateway <ip-address>
default-gateway - set the default gateway ip address
enable [user|admin]
change access privilege level
-(26%)-Use <CR> to continue, q to stop:
help
display help menu
ignore enable-password
ignore enable password
ignore startup-config
ignore system starup-config
interface management ethernet ip address <ip/mask>
set the management port ip address and mask
interface management port config 1000m
set the management port at 1000m
interface management port config 100m
set the management port at 100m
interface management port config 10m
set the management port at 10m
interface management port config auto-negotiate
set the management port to auto negotiate
interface management port config full-duplex
set the management port to full-duplex
interface management port config half-duplex
set the management port to half-duplex
-(60%)-Use <CR>> to continue, q to stop:
interface management port config no auto-negotiate
set the management port to no auto negotiate. set speed and duplex
to def
ault values of (100m/full-duplex)
no default-gateway
clear the default gateway ip address
no interface management ethernet ip address
174
Boot User Mode