Users Guide

Boot User Mode
All commands in this chapter are available in Boot User mode on the S5000.
To access this mode, press any key when the following line appears on the console during a system boot:
Hit any key to stop autoboot:
You enter Boot User mode immediately, as indicated by the BOOT_USER# prompt.
NOTE: You cannot use the Tab key to complete commands in this mode.
Topics:
• boot change
• boot messages disable
• boot messages enable
•
boot show net config retries
• boot write net config retries
• boot zero
• default gateway
• enable
• help
• ignore enable password
• enable sha256-password
• ignore startup config
• interface management ethernet ip address
• interface management port config
• no default-gateway
• no interface management ethernet ip address
• reload
• show boot blc
• show boot selection
• show bootflash
• show bootvar
• show default-gateway
• show interface management ethernet
• show interface management port config
boot change
Change the boot parameters in the operating system.
S5000
Syntax
boot change {primary | secondary | default}
Command Modes BOOT USER
Parameters
primary Set the S5000 to boot up with the primary boot parameters.
secondary Set the S5000 to boot up with the secondary boot parameters.
6
Boot User Mode 171