Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S5000

1701

memory devices (for example, SDRAM, flash, NVRAM, EEPROM, and CPLD)

wherever possible. There are no tests on 10G links. At this level, stack ports are

shut down automatically.

level2 Enter the keyword level2 to run Level 2 diagnostics. Level 2 diagnostics are a full

set of diagnostic tests with no support for automatic partitioning. Level 2

diagnostics are used primarily for on-board loopback tests and more extensive

component diagnostics. Various components on the board are put into Loopback

mode and test packets are transmitted through those components. These

diagnostics also perform snake tests using VLAN configurations. To test 10G links,

physically remove the unit from the stack.

verbose Enter the keyword verbose to run the diagnostic in Verbose mode. Verbose mode

gives more information in the output than Standard mode.

testname Enter the keyword testname to run a specific test case. Enclose the test case

name in double quotes (“ “). For example: diag stack-unit 1 level1

testname “first”. You can use this option only for interactive tests.

Defaults None

Command Modes EXEC Privilege

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

Version Description

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.3.1.0 Introduced the verbose option.

7.7.1.0 Introduced on the S-Series.

offline stack-unit

Place a stack unit in the offline state.

Syntax

offline stack-unit number

Parameters

number

Enter the stack-unit id.