Users Guide

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
The VRRP group only becomes active and sends VRRP packets when you configure a virtual IP address.
When you delete the virtual IP address, the VRRP group stops sending VRRP packets.
Related
Command
● virtual-address — assigns up to 12 virtual IP addresses per VRRP group.
IPv6 VRRP Commands
The following are IPv6 VRRP commands.
● clear counters vrrp ipv6
● debug vrrp ipv6
● show vrrp ipv6
● vrrp-ipv6-group
The following commands apply to IPv4 and IPv6:
● advertise-interval
● description
● disable
● hold-time
● preempt
● priority
● show config
● virtual-address
clear counters vrrp ipv6
Clear the counters recorded for IPv6 VRRP groups.
Syntax
clear counters vrrp ipv6 [vrid | vrf vrf-name]
Parameters
vrid (OPTIONAL) Enter the number of an IPv6 VRRP group; range is from 1 to 255.
vrf vrf-name (OPTIONAL) Enter the name of a VRF instance to clear the counters of all IPv6
VRRP groups in the specified VRF. The maximum is 32 characters.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.9(0.0) Added support to clear the interface configurations corresponding to a range of
ports.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
1696 Virtual Router Redundancy Protocol (VRRP)