Users Guide

Related
Commands
dei honor — Honor the incoming DEI value by mapping it to an Dell Networking OS drop precedence.
show interface dei-mark
Display the dei mark configuration.
Syntax
show interface dei-mark [interface slot/port | linecard number port-set
number]
Parameters
interface slot/
port
Enter the interface type followed by the line card slot and port number.
linecard number
port-set number
Enter linecard followed by the line card slot number, then enter port-set
followed by the port-pipe number.
Command Modes EXEC Privilege
Command
History
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on the C-Series and S-Series.
Example
Dell#show interface dei-mark
Default CFI/DEI Marking: 0
Interface Drop precedence CFI/DEI
------------------------------------------------
Gi 0/1 Green 0
Gi 0/1 Yellow 1
Gi 8/9 Yellow 0
Gi 8/40 Yellow 0
Related
Commands
dei mark — Set the DEI value on egress according to the color currently assigned to the packet.
stack-unit stack-group
Configure a stacking group specified by an ID.
Syntax
[no] stack-unit unit-id stack-group stack-group-id
To remove the current stack group configuration, use the no stack-unit unit-id stack-group
stack-id command.
Parameters
unit-id Enter the stack unit ID.
stack-group-id Enter the stack group ID. The range is from 0 to 16.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
VLAN Stacking 1637