Users Guide

...
13 0/48
14 0/52
15 0/56
16 0/60
stack-unit location-led
Toggle the stack unit location LED on or off.
Syntax
stack-unit stack-unit-number location—led {off | on}
Parameters
stack-unit stack-
unit-number
Enter the keyword stack-unit and the stack unit number. .
on | off Turn the stack unit location LED on or off.
Default
None
Command Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced on the S6100–ON and S5000.
9.8(1.0) Introduced on the Z9100–ON.
Example
Dell#
Dell#stack-unit 1 location-led on
stack-unit priority
Configure the ability of a switch to become the management unit of a stack.
Syntax
stack-unit stack-number priority priority-value
Parameters
stack-number Enter the stack member unit identifier.
priority-value This preference parameter allows you to specify the management priority of one
backup switch over another, with 1 as the lowest priority and 14 being the highest.
The switch with the highest priority value is chosen to become the management
unit if the active management unit fails or on the next reload.
Defaults 1
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
1564 Stacking Commands