Users Guide

● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a Null interface, enter the keyword null then the Null interface number.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults The IP address assigned to the management interface is the default.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810
8.5.1.0 Added support for 4-port 40G line cards.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
To enable this snmp-server trap-source command, configure an IP address on the interface and
enable the interface configured as an SNMP trap source.
Related
Commands
● snmp-server community — sets the community string.
snmp-server user
Configure a new user to an SNMP group.
Syntax
snmp-server user name {group_name remote ip-address vrf vrf-name udp-port
port-number} [1 | 2c | 3] [encrypted] [auth {md5 | sha} auth-password]
[priv {des56 | aes128} priv password] [access access-list-name | ipv6
access-list-name | access-list-name ipv6 access-list-name]
To remove a user from the SNMP group, use the no snmp-server user name {group_name
remote ip-address udp-port port-number} [1 | 2c | 3] [encrypted] [auth {md5
| sha} auth-password] [priv {des56 | aes128} priv password] [access access-
list-name | ipv6 access-list-name | access-list-name ipv6 access-list-name]
command.
Parameters
name Enter the name of the user (not to exceed 20 characters), on the host that
connects to the agent.
Simple Network Management Protocol (SNMP) and Syslog 1525