Users Guide

● envmon — For Dell Networking device notifications when an environmental
threshold is exceeded.
● isis — Notification of intermediate service traps.
● lacp — Notification of changes.
● snmp — Notification of RFC 1157 traps.
● stp — Notification of a state change in the spanning tree protocol (RFC 1493).
● vlt — Notification of virtual link trunking.
● vrrp — Notification of a state change in a VRRP group.
● xstp — Notification of a state change in MSTP (802.1s), RSTP (802.1w), and
PVST+.
notification-
option
For the envmon notification-type, enter one of the following optional parameters:
● cam-utilization
● fan
● supply
● temperature
For the snmp notification-type, enter one of the following optional parameters:
● authentication
● coldstart
● linkdown
● linkup
● syslog-reachable
● syslog-unreachable
Defaults Not enabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the following two SNMP notification options: syslog-reachable and
syslog-unreachable.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
9.1(0.0) Added support for copy-config and ECMP traps.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.4.1.0 Added support for VRRP traps.
7.6.1.0 Added support for STP and xSTP traps. Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Simple Network Management Protocol (SNMP) and Syslog 1517