Users Guide

To delete an offset list, use the no offset-list prefix-list-name {in | out} offset
[interface] command.
Parameters
prefix-list-name Enter the name of an established Prefix list to determine which incoming routes are
modified.
offset Enter a number from zero (0) to 16 to be applied to the incoming route metric
matching the access list specified. If you set an offset value to zero (0), no action
is taken.
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN, enter the keyword vlan then a number from 1 to 4094.
Defaults Not configured.
Command Modes ROUTER RIP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage
Information
When the offset metric is applied to an interface, that value takes precedence over an offset value that is
not extended to an interface.
Related
Commands
● ip prefix-list — enters PREFIX-LIST mode and configure a prefix list.
output-delay
Set the interpacket delay of successive packets to the same neighbor.
Syntax
output-delay delay
To return to the switch software defaults for interpacket delay, use the no output-delay command.
Routing Information Protocol (RIP) 1371