Users Guide

• ip ospf retransmit-interval
• ip ospf transmit-delay
• log-adjacency-changes
• maximum-paths
• mib-binding
• network area
• passive-interface
• debug ip ospf
• redistribute bgp
• redistribute isis
• router-id
• router ospf
• show config
• show ip ospf
• show ip ospf asbr
• show ip ospf database
• show ip ospf database asbr-summary
• show ip ospf database external
• show ip ospf database network
• show ip ospf database nssa-external
• show ip ospf database opaque-area
• show ip ospf database opaque-as
• show ip ospf database opaque-link
• show ip ospf database router
• show ip ospf database summary
• show ip ospf interface
• show ip ospf neighbor
• show ip ospf routes
• show ip ospf statistics
• show ip ospf timers rate-limit
• show ip ospf topology
• show ip ospf virtual-links
• summary-address
• timers spf
• timers throttle lsa all
• timers throttle lsa arrival
• OSPFv3 Commands
area default-cost
Set the metric for the summary default route the area border router (ABR) generates into the stub area. Use this command on
the border routers at the edge of a stub area.
Syntax
area area-id default-cost cost
To return default values, use the no area area-id default-cost command.
Parameters
area-id Specify the OSPF area in dotted decimal format (A.B.C.D.) or enter a number from
zero (0) to 65535.
cost Specifies the stub area’s advertised external route metric. The range is from zero
(0) to 65535.
Defaults cost = 1; no areas are configured.
Command Modes ROUTER OSPF
Open Shortest Path First (OSPFv2 and OSPFv3) 1143