Users Guide

Command Modes
● EXEC
● EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Use the show interfaces fibrechannel command to display information on the Fibre Channel
capability of a switch.
The following table describes the show fc switch output shown in the following example.
Switch Mode Fibre Channel mode of operation of an S5000 switch. Default: NPG (configured as
an NPIV proxy gateway).
Switch WWN Factory-assigned worldwide node (WWN) name of the S5000. The S5000 WWN
name is not user-configurable.
Example
Dell# show fc switch
Switch Mode : NPG
Switch WWN : 10:00:5c:f9:dd:ef:10:c0
Dell#
Related
Commands
interface fibrechannel — configures a Fibre Channel interface on the switch.
show interfaces fibrechannel — displays the configuration of a Fibre Channel interface.
show qos dcb-map
Display the DCB parameters configured in a specified DCB map.
S5000
Syntax
show qos dcb-map map-name
Parameters
map-name Displays the PFC and ETS parameters configured in the specified map.
Command Modes
● EXEC
● EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Use the show qos dcb-map command to display the enhanced transmission selection (ETS) and
priority-based flow control (PFC) parameters used to configure server-facing Ethernet ports. S5000
Ethernet ports are DCBx-enabled by default.
The following table describes the show qos dcb-map output shown in the example below.
Field Description
State Complete: All mandatory DCB parameters are correctly configured. In progress: The
DCB map configuration is not complete. Some mandatory parameters are not
configured.
PFC Mode PFC configuration in DCB map: On (enabled) or Off.
PG Priority group configured in the DCB map.
TSA Transmission scheduling algorithm used by the priority group: Enhanced
Transmission Selection (ETS).
BW Percentage of bandwidth allocated to the priority group.
1140 NPIV Proxy Gateway