Users Guide

priority-pgid – configures the 802.1p priority traffic in a priority group for a DCB map.
show fcoe-map
Display the Fibre Channel and FCoE configuration parameters in FCoE maps.
S5000
Syntax
show fcoe-map [brief | map-name]
Parameters
brief Displays an overview of currently configured FCoE maps.
map-name Displays the FC and FCoE configuration parameters in a specified FCoE map. The
FCoE map is applied on Ethernet (FCoE) and FC ports to transmit FC storage
traffic to a specified fabric.
Command Modes
● EXEC
● EXEC Privilege
Command
History
Version 9.1(1.0) Included support for Fabric Services mode, switch configuration, and switch zoning
parameters.
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Use the show fcoe-map command to display the FC and FCoE parameters used to configure server-
facing Ethernet (FCoE) and fabric-facing FC ports in all FCoE maps on an S5000 NPIV proxy gateway.
In each FCoE map, the values for the fabric ID and FC-MAP that identify the SAN fabric to which FC
storage traffic is sent, and the FCoE VLAN to be used must be unique.
An FCoE map is used to identify the SAN fabric to which FCoE storage traffic is sent and to virtualize
S5000 FC ports so that they appear to downstream server CNA ports as FCoE Forwarder (FCF) ports on
an FCoE network.
The following table describes the show fcoe-map brief and show fcoe-map map-name output
shown in the examples below.
Field Description
Fabric-Name Name of a SAN fabric.
Fabric ID The ID number of the SAN fabric to which FC traffic is forwarded.
VLAN ID The dedicated FCoE VLAN used to transport FCoE storage traffic between servers
and a fabric over the NPIV proxy gateway. The configured VLAN ID must be the
same as the fabric ID.
VLAN priority FCoE traffic uses VLAN priority 3. (This setting is not user-configurable.)
FC-MAP FCoE MAC address-prefix value - The unique 24-bit MAC address prefix that
identifies a fabric.
FKA-ADV-period Time interval (in seconds) used to transmit FIP keepalive advertisements.
FCF Priority The priority used by a server to select an upstream FCoE forwarder.
Config-State Indicates whether the configured FCoE and FC parameters in the FCoE map are
valid: Active (all mandatory FCoE and FC parameters are correctly configured) or
Incomplete (either the FC-MAP value, fabric ID, or VLAN ID are not correctly
configured).
Oper-State Operational status of link to the fabric: Up (link is up and transmitting FC traffic),
Down (link is down and not transmitting FC traffic), Link-wait (link is up and
1136 NPIV Proxy Gateway