Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S5000

1081

Multicast

The multicast commands are supported by Dell Networking OS on all platform.

Topics:

• IPv4 Multicast Commands

• clear ip mroute

• ip mroute

• ip multicast-limit

• ip multicast-routing

• show ip mroute

• show ip rpf

• IPv6 Multicast Commands

• ip multicast-limit

IPv4 Multicast Commands

The following section contains the IPv4 multicast commands.

clear ip mroute

Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent multicast (PIM) tree

information base, use the clear ip pim tib command.

S5000

Syntax

clear ip mroute [vrf vrf-name] {group-address [source-address] | * |

snooping}

Parameters

vrf

vrf-name

(OPTIONAL) Enter the keyword vrf followed by the name of the VRF to configure

this setting on that VRF.

NOTE: Applies to specific VRF if input is provided, else applies to Default VRF.

group-address

[

source-address

]

Enter the multicast group address and source address (if desired), in dotted

decimal format, to clear information on a specific group.

* Enter * to clear all multicast routes.

snooping Enter the keyword snooping to delete multicast snooping route table entries.

Command Modes EXEC Privilege

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

Version Description

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

Multicast 1087