Reference Guide

804 | Service Provider Bridging
www.dell.com | support.dell.com
Display the status and members of a VLAN using the show vlan command from EXEC Privilege mode.
Members of a VLAN-Stacking-enabled VLAN are marked with an M in column Q.
Figure 45-3. Display the Members of a VLAN-Stacking-enabled VLAN
Configuring the Protocol Type Value for the Outer VLAN Tag
The Tag Protocol Identifier (TPID) field of the S-Tag is user-configurable:
Display the S-Tag TPID for a VLAN using the command show running-config from EXEC privilege mode.
Dell Networking OS displays the S-Tag TPID only if it is a non-default value.
Dell Networking OS Options for Trunk Ports
802.1ad trunk ports may also be tagged members of a VLAN so that it can carry single and double-tagged
traffic.
You can enable trunk ports to carry untagged, single-tagged, and double-tagged VLAN traffic by making
the trunk port a hybrid port.
Task Command Syntax Command Mode
Select a value for the S-Tag TPID.
Default: 9100
CONFIGURATION
vlan-stack protocol-type
Step Task Command Syntax Command Mode
1 Configure a trunk port to carry untagged, single-tagged, and
double-tagged traffic by making it a hybrid port.
Note: Note: On the S5000, a trunk port can be added to
an 802.1Q VLAN as well as a Stacking VLAN only when
the TPID 0x8100.
portmode hybrid
INTERFACE
2 Add the port to a 802.1Q VLAN as tagged or untagged. [tagged | untagged] INTERFACE VLAN
Dell#show vlan
Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port Mirroring VLANs, P - Primary, C
- Community, I - Isolated
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged
NUM Status Description Q Ports
* 1 Active U Te 0/0-2
1002 Active T Te 0/0-2
Dell#