Reference Guide

532 | IPv6 Routing
www.dell.com | support.dell.com
SNMP over IPv6
SNMP is supported on the S5000 platform.
Simple Network Management Protocol (SNMP) can be configured over IPv6 transport so that an IPv6 host
can perform SNMP queries and receive SNMP notifications from a device running Dell Networking OS
IPv6. The Dell Networking OS SNMP-server commands for IPv6 have been extended to support IPv6.
Refer to the
SNMP and SYSLOG chapter in the Dell Networking OS Command Line Interface Reference for
more information regarding SNMP commands.
• snmp-server host
• snmp-server user ipv6
• snmp-server community ipv6
• snmp-server community access-list-name ipv6
• snmp-server group ipv6
• snmp-server group access-list-name ipv6
Showing IPv6 Information
All of the following show commands are supported on the S5000 platform.
View specific IPv6 configuration with the following commands.
Command Syntax Command Mode Purpose
telnet
ipv6 address EXEC or
EXEC Privileged
Enter the IPv6 Address for the device.
ipv6 address : x:x:x:x::x
mask : prefix length 0-128
IPv6 addresses are normally written as eight groups of four hexadecimal digits, where
each group is separated by a colon (:). Omitting zeros is accepted as described in
Addressing earlier in this chapter.
Command Syntax Command Mode Purpose
show ipv6 ? EXEC or
EXEC Privileged
List the IPv6 show options