Reference Guide

IPv6 Routing | 529
Configuration Task List for IPv6
This section contains information regarding the following:
• Adjusting your CAM-Profile
• Assigning an IPv6 Address to an Interface
• Assigning a Static IPv6 Route
• Telneting with IPv6
• SNMP over IPv6
• Showing IPv6 Information
• Showing an IPv6 Interface
• Showing IPv6 Routes
• Showing the Running-Configuration for an Interface
• Clearing IPv6 Routes
Adjusting your CAM-Profile
The cam-acl command is supported on the S5000 platform.
Although this is not a mandatory step, if you plan to implement IPv6 ACLs, you must adjust your CAM
settings.
The CAM space is allotted in FP blocks. The total space allocated must equal 13 FP blocks. Note that there
are 16 FP blocks, but the System Flow requires 3 blocks that cannot be reallocated.
The
ipv6acl allocation must be entered as a factor of 2 (2, 4, 6, 8, 10). All other profile allocations can use
either even or odd numbered ranges.
The
default option sets the CAM Profile as follows:
• L3 ACL (ipv4acl): 6
• L2 ACL(l2acl) : 5
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 1
• L2 QoS (l2qos): 1