Reference Guide

460 | Fibre Channel Interface
www.dell.com | support.dell.com
Figure 23-7. stack-unit port-group portmode ethernet Command Example
To change to fibre channel mode, use the no stack-unit unit-number port-group number portmode ethernet
command.
Figure 23-8. no stack-unit port-group portmode ethernet Command Example
Displaying Fibre Channel Port Group Mode Information
To display the fibre channel port-group mode information, use the following show command:
Figure 23-9. show system stack-unit Command Example
Dell(conf)#stack-unit 0 port-group 0 portmode ethernet
Changing port mode on slot 0 port-group 0 will make interface configs of 0 and 1 obsolete after a save and
reload.
[confirm yes/no]:yes
Please save and reload for the changes to take effect.
Dell(conf)#
Dell(conf)#no stack-unit 0 port-group 0 portmode ethernet
Changing port mode on slot 0 port-group 0 will make interface configs of 0 and 1 obsolete after a save and
reload.
[confirm yes/no]:yes
Please save and reload for the changes to take effect.
Dell(conf)#
Dell#show system stack-unit 0 port-group portmode
PortGroupId Ports Mode(Curr Boot) Mode(Next Boot)
0 0,1 FC FC
1 2,3 FC FC
2 4,5 ETH FC
3 6,7 FC ETH
4 8,9 FC FC
5 10,11 FC FC
Dell#