Reference Guide

374 | Force10 Resilient Ring Protocol (FRRP)
www.dell.com | support.dell.com
Setting FRRP Timers
Clearing FRRP counters
Use one of the following commands to clear the FRRP counters.
Showing FRRP configuration
Use the following command to view the configuration for the FRRP group.
Showing FRRP information
Use one of the following commands show general FRRP information.
Step Command Syntax Command Mode Purpose
1
timer
{hello-interval|dead-interval}
milliseconds
CONFIG-FRRP Enter the desired intervals for Hello-Interval or
Dead-Interval times.
Hello-Interval: 50-2000, in increments of 50
(default is 500)
Dead-Interval: 50-6000, in increments of 50
(default is 1500)
The Dead-Interval time should be set at 3x the Hello-Interval.
Command Syntax Command Mode Purpose
clear frrp ring-id EXEC PRIVELEGED Clear the counters associated with this Ring ID
Ring ID: 1-255
clear frrp
EXEC PRIVELEGED Clear the counters associated with all FRRP
groups
Command Syntax Command Mode Purpose
show configuration
CONFIG-FRRP Show the configuration for this FRRP group
Command Syntax Command Mode Purpose
show frrp ring-id EXEC or EXEC
PRIVELEGED
Show the information for the identified FRRP
group.
Ring ID: 1-255
show frrp summary
EXEC or EXEC
PRIVELEGED
Show the state of all FRRP groups.
Ring ID: 1-255