Reference Guide

Configuration Fundamentals | 37
You can install Ethernet module in any slot (0 to 3) and Universal Port module in slot 0 on the I/O panel.
On the S5000, the valid stack-unit numbers are 0 to 11. The valid port numbers for each interface type are
listed below.
• 1GbE: Ports 0-47
• 10GbE: Ports 0-63
• 40GbE: Ports 48, 52, 56, and 60
• Universal Port: Ports 0-47
• Management: Port 0
• Fiber Channel: Ports 0-11
The do Command
Enter an EXEC mode command from any CONFIGURATION mode (CONFIGURATION, INTERFACE,
SPANNING TREE, etc.) without returning to EXEC mode by preceding the EXEC mode command with
the command
do. The following example illustrates the do command.
Figure 2-4. Using the do Command
Note: The following commands cannot be modified by the do command: enable, disable, exit, and configure.
Dell(conf)#do show system brief
Stack MAC : 5c:f9:dd:ee:ff:c0
Reload-Type : normal-reload [Next boot : normal-reload]
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
----------------------------------------------------------------------------
0 Management online S5000 S5000 9-0-1-0 64
1 Member not present
2 Member not present
3 Member not present
4 Member not present
5 Member not present
6 Member not present
7 Member not present
8 Member not present
9 Member not present
10 Member not present
11 Member not present
-- Module Info --
Unit Module No Status Module Type Ports
---------------------------------------------------------------------------
Dell(conf)#
“do” form of show command