Reference Guide

322 | Data Center Bridging (DCB)
www.dell.com | support.dell.com
Debugging DCBx on an Interface
To enable DCBx debug traces for all or a specific control path, use the following command:
Task Command Command Mode
Enable DCBx debugging, where:
• all: Enables all DCBx debugging operations.
auto-detect-timer: Enables traces for DCBx
auto-detect timers.
•
config-exchng: Enables traces for DCBx
configuration exchanges.
•
fail: Enables traces for DCBx failures.
• mgmt: Enables traces for DCBx management
frames.
• resource: Enables traces for DCBx system
resource frames.
• sem: Enables traces for the DCBx state machine.
• tlv: Enables traces for DCBx TLVs.
debug DCBx {all | auto-detect-timer
| config-exchng | fail | mgmt |
resource | sem | tlv}
EXEC PRIVILEGE