Reference Guide

1026 | S5000 Debugging and Diagnostics
www.dell.com | support.dell.com
You must reload the system for the global buffer profile to take effect (Message 5).
The buffer-profile global command fails if you have already applied a custom buffer profile on an interface.
Similarly, when you configure
buffer-profile global, you cannot not apply a buffer profile on any single
interface.
If the default buffer profile (4Q) is active, Dell networking OS displays an error message instructing you to
remove the default configuration using the command
no buffer-profile global command.
Message 5 Reload After Applying Global Buffer Profile
% Info: For the global pre-defined buffer profile to take effect, please save the config and reload the
system.
Dell Networking OS Behavior: After you configure buffer-profile global 1Q, Message 5 is displayed during every
bootup. Only one reboot is required for the configuration to take effect; afterwards this bootup message may be
ignored.
Dell Networking OS Behavior: The buffer profile does not returned to the default, 4Q, if you configure 1Q, save the
running-config to the startup-config, and then delete the startup-config and reload the chassis. The only way to
return to the default buffer profile is to explicitly configure 4Q, and then reload the chassis.
Message 6 Global Buffer Profile Error
% Error: User-defined buffer profile already applied. Failed to apply global pre-defined buffer profile.
Please remove all user-defined buffer profiles.
Message 7 Global Buffer Profile Error
% Error: Global pre-defined buffer profile already applied. Failed to apply user-defined buffer profile
on interface Te 0/1. Please remove global pre-defined buffer profile.