Users Guide

NUM Status Q Ports
* 1 Inactive
2 Active T Po1(So 0/0-1)
T Te 3/0
3 Active T Po1(So 0/0-1)
T Te 3/1
4 Active T Po1(So 0/0-1)
Dell#
When you remove a tagged interface from a VLAN (using the no tagged interface command), it remains tagged only if it is a
tagged interface in another VLAN. If the tagged interface is removed from the only VLAN to which it belongs, the interface is placed
in the Default VLAN as an untagged interface.
Moving Untagged Interfaces
To move untagged interfaces from the Default VLAN to another VLAN, use the following commands.
1. Access INTERFACE VLAN mode of the VLAN to which you want to assign the interface.
CONFIGURATION mode
interface vlan vlan-id
2. Congure an interface as untagged.
INTERFACE mode
untagged interface
This command is available only in VLAN interfaces.
Move an Untagged Interface to Another VLAN
The no untagged interface command removes the untagged interface from a port-based VLAN and places the interface in
the Default VLAN. You cannot use the no untagged interface command in the Default VLAN. The following example shows
the steps and commands to move an untagged interface from the Default VLAN to another VLAN.
The only way to remove an interface from the Default VLAN is to place the interface in Default mode by entering the no
switchport
command in INTERFACE mode.
Dell#show vlan
Codes: * - Default VLAN, G - GVRP VLANs
NUM Status Q Ports
* 1 Active U Te 3/2
2 Active T Po1(So 0/0-1)
T Te 3/0
3 Active T Po1(So 0/0-1)
T Te 3/1
4 Inactive
Dell#conf
Dell(conf)#int vlan 4
Dell(conf-if-vlan)#
untagged gi 3/2
Dell(conf-if-vlan)#show config
!
interface Vlan 4
no ip address
untagged TenGigabitEthernet 3/2
Dell(conf-if-vlan)#end
Dell#
show vlan
Codes: * - Default VLAN, G - GVRP VLANs
NUM Status Q Ports
* 1 Inactive
906
Virtual LANs (VLANs)