Users Guide

Transactions between the RADIUS server and the client are encrypted (the users’ passwords are not sent in plain text). RADIUS
uses UDP as the transport protocol between the RADIUS server host and the client.
For more information about RADIUS, refer to RFC 2865, Remote Authentication Dial-in User Service.
RADIUS Authentication and Authorization
Dell Networking OS supports RADIUS for user authentication (text password) at login and can be specied as one of the login
authentication methods in the
aaa authentication login command.
When conguring AAA authorization, you can congure to limit the attributes of services available to a user. When authorization is
enabled, the network access server uses conguration information from the user prole to issue the user's session. The user’s
access is limited based on the conguration attributes.
RADIUS exec-authorization stores a user-shell prole and that is applied during user login. You may name the relevant named-lists
with either a unique name or the default name. When the RADIUS server enables authorization, the server returns the following
information to the client:
• Idle time
• ACL conguration information
• Auto-command
• Privilege level
After gaining authorization for the rst time, you may congure these attributes.
NOTE: RADIUS authentication/authorization is done for every login. There is no dierence between rst-time login and
subsequent logins.
Idle Time
Every session line has its own idle-time. If the idle-time value is not changed, the default value of 30 minutes is used.
RADIUS species idle-time allow for a user during a session before timeout. When a user logs in, the lower of the two idle-time
values (congured or default) is used. The idle-time value is updated if both of the following happen:
• The administrator changes the idle-time of the line on which the user has logged in.
• The idle-time is lower than the RADIUS-returned idle-time.
ACL Conguration Information
The RADIUS server can specify an ACL. If an ACL is congured on the RADIUS server, and if that ACL is present, the user may be
allowed access based on that ACL.
If the ACL is absent, authorization fails, and a message is logged indicating this.
RADIUS can specify an ACL for the user if both of the following are true:
• If an ACL is absent.
• If there is a long delay for an entry, or a denied entry because of an ACL, and a message is logged.
NOTE: The ACL name must be a string. Only standard ACLs in authorization (both RADIUS and TACACS) are supported.
Authorization is denied in cases using Extended ACLs.
Auto-Command
You can congure the system through the RADIUS server to automatically execute a command when you connect to a specic line.
The auto-command command is executed when the user is authenticated and before the prompt appears to the user.
• Automatically execute a command.
auto-command
Security
765