Users Guide
Figure 117. Example of Conīguring Interfaces for Layer 2 Mode
1. If the interface has been assigned an IP address, remove it.
INTERFACE mode
no ip address
2. Place the interface in Layer 2 mode.
INTERFACE mode
switchport
3. Enable the interface.
INTERFACE mode
no shutdown
Example of Verifying that an Interface is in Layer 2 Mode and Enabled
To verify that an interface is in Layer 2 mode and enabled, use the show config command from INTERFACE mode. The bold lines
indicate that the interface is in Layer 2 mode.
Dell(conf-if-te-1/1)#show config
!
interface TenGigabitEthernet 1/1
no ip address
Rapid Spanning Tree Protocol (RSTP)
747