Users Guide

nlbclusteracl 0
FcoeAcl 0
iscsiOptAcl 0
ipv4pbr 0
vrfv4Acl 0
Openow 0
fedgovacl 0
Re-Allocating CAM for Ingress ACLs and QoS
The default CAM allocation settings for ingress ACL and QoS regions are shown in the following list.
• L2 ACL(l2acl): 4
• L3 ACL (ipv4acl): 4
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 2
• L2 QoS (l2qos): 1
• L2PT (l2pt): 0
• MAC ACLs (ipmacacl): 0
• ECFMACL (ecfmacl): 0
• VMAN QoS (vman-qos): 0
• VMAN Dual QoS (vman-dual-qos): 0
• FCoE ACL (fcoeacl): 2
• iSCSI Opt ACL (iscsioptacl): 0
Enter the ipv6acl and vman-dual-qos allocations as a factor of 2 (2, 4, 6, 8, 10). All other CAM regions can use either even or
odd numbered numbers.
NOTE: On the S5000, there can be only one odd number of Blocks in the CLI conguration; the other Blocks must be in
factors of 2. For example, a CLI conguration of 5+4+2+1+1 Blocks is not supported; a conguration of 6+4+2+1 Blocks is
supported.
You must save the new CAM settings to the startup-cong (write-mem or copy run start) then reload the system for the
new settings to take eect.
To recongure the memory regions on the S5000 used for ingress ACLs and QoS, follow these steps.
1. Enter a CAM allocation action to perform on ingress ACLs.
CONFIGURATION mode
cam-acl [default | l2acl]
NOTE: Selecting default resets the CAM entries to the default settings. To re-allocate memory space for ingress
ACL and QoS regions, select l2acl.
2. Enter the number of FP blocks for each region. Separate each keyword and number with a blank space. The total CAM space
allocated must equal 13.
EXEC Privilege mode
Content Addressable Memory (CAM)
233