Users Guide

• Creating a Route Map (mandatory)
• Congure Route Map Filters (optional)
• Congure a Route Map for Route Redistribution (optional)
• Congure a Route Map for Route Tagging (optional)
Creating a Route Map
Route maps, ACLs, and prex lists are similar in composition because all three contain lters, but route map lters do not contain the
permit and deny actions found in ACLs and prex lists.
Route map lters match certain routes and set or specify values.
To create a route map, use the following command.
• Create a route map and assign it a unique name. The optional permit and deny keywords are the action of the route map.
CONFIGURATION mode
route-map map-name [permit | deny] [sequence-number]
The default is permit.
The optional seq keyword allows you to assign a sequence number to the route map instance.
Example of Viewing a Congured Route Map
Example of Matching Instances of a Route-Map
Example of Deleting Instances of a Route Map
Example of Viewing All Instances of a Specied Route Map
The default action is permit and the default sequence number starts at 10. When you use the keyword deny in conguring a route
map, routes that meet the match lters are not redistributed.
To view the conguration, use the show config command in ROUTE-MAP mode.
Dell(config-route-map)#show config
!
route-map dilling permit 10
Dell(config-route-map)#
You can create multiple instances of this route map by using the sequence number option to place the route maps in the correct
order. Dell Networking OS processes the route maps with the lowest sequence number rst. When a congured route map is applied
to a command, such as
redistribute, trac passes through all instances of that route map until a match is found. The following
is an example with two instances of a route map.
Dell#show route-map
route-map zakho, permit, sequence 10
Match clauses:
Set clauses:
route-map zakho, permit, sequence 20
Match clauses:
interface GigabitEthernet 0/1
Set clauses:
tag 35
level stub-area
Dell#
To delete all instances of that route map, use the no route-map map-name command. To delete just one instance, add the
sequence number to the command syntax.
Dell(conf)#no route-map zakho 10
Dell(conf)#end
Access Control Lists (ACLs)
135