Reference Guide

IPv6 Routing | 525
Assigning a Static IPv6 Route
IPv6 Static Routes are supported on the S5000 platform.
Use the
ipv6 route command to configure IPv6 static routes.
Note: After you configure a static IPv6 route (ipv6 route command) and configure the forwarding router’s address
(specified in the
ipv6 route command) on a neighbor’s interface, the IPv6 neighbor is not displayed in the show ipv6
route
command output.
Telneting with IPv6
IPv6 Telnet is supported on the S5000 platform.
The Telnet client and server in FTOS support IPv6 connections. You can establish a Telnet session directly
to the router using an IPv6 Telnet client, or an IPv6 Telnet connection can be initiated from the router.
Command Syntax Command Mode Purpose
ipv6 route
prefix type {slot/port}
forwarding router tag
CONFIGURATION Set up IPv6 static routes
prefix: IPv6 route prefix
type {slot/port}: interface type and slot/port
forwarding router: forwarding router’s address
tag: route tag
Enter the keyword
interface followed by the type of
interface and slot/port information:
• For a Gigabit Ethernet interface, enter the
keyword
GigabitEthernet followed by the slot/
port information.
• For a 10 Gigabit Ethernet interface, enter the
keyword
TenGigabitEthernet followed by the
slot/port information.
• For a 40-Gigabit Ethernet interface, enter the
keyword
fortyGigE followed by the slot/port
information.
• For a loopback interface, enter the keyword
loopback followed by the loopback number
• For a port-channel interface, enter the keyword
port-channel followed by the port-channel
number
• For a VLAN interface, enter the keyword
vlan
followed by the VLAN ID
• For a Null interface, enter the keyword
null
followed by the Null interface number
Note: Telnet to link local addresses is not supported.