Reference Guide

448 | Interfaces
www.dell.com | support.dell.com
Displaying Fibre Channel Information
Use the show commands in Table 21-4 to display information on switch-wide and interface-specific Fibre
Channel operation.
2
speed {auto | 2G | 4G | 8G}
INTERFACE
FIBRE_CHANNEL
Configure the speed of an FC port. The valid values
are: 2, 4 or 8 Gbps or autosensing.
Default: An FC port autosenses the speed of a peer
FC port.
3
fabric fcoe-map-name
INTERFACE
FIBRE_CHANNEL
Configure the SAN fabric to which an FC port
connects by entering the name of the FCoE map
applied to the interface. The FCoE map contains
FCoE and FC parameter settings (see FCoE Maps).
4
no shutdown
INTERFACE
FIBRE_CHANNEL
Enable the Fibre Channel port.
Table 21-4. Displaying FC Information
Command Output
show interfaces fibrechannel (Figure 21-33) Displays the configuration of an FC interface.
clear counters fibrechannel slot/port Clears the statistics (counters) displayed in show interfaces fibrechannel
command output for a specified FC port.
show fc switch (Figure 21-34) Displays the switch configuration for Fibre Channel capability.
Step Command Syntax Command Mode Purpose