Reference Guide

434 | Interfaces
www.dell.com | support.dell.com
Figure 21-22. Define an Interface Range Macro
Choosing an Interface-range Macro
To use an interface-range macro in the interface range command, enter this command:
The example below shows how to change to the interface-range configuration mode using the
interface-range macro named “test.”
Figure 21-23. Change the Interface Range Configuration
Monitoring and Maintaining Interfaces
Monitor interface statistics with the monitor interface command. This command displays an ongoing list of
the interface status (up/down), number of packets, traffic statistics, etc.
Command Syntax Command Mode Purpose
interface range macro name CONFIGURATION Selects the interfaces range to be configured using the values
saved in a named interface-range macro.
Command Syntax Command Mode Purpose
monitor interface interface EXEC Privilege View the interface’s statistics. Enter the type of interface and
slot/port information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For the Management interface, enter the keyword
ManagementEthernet followed by the slot/port
information.
• For a 10 Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
FTOS(conf)# define interface-range test tengigabitethernet 0/1 - 4
FTOS(conf)# interface range macro test
FTOS(conf-if)#