Reference Guide

Interfaces | 419
Displaying a Management Interface Configuration
You can manage the S5000 from any port. Configure an IP address for the port using the ip address
command, and enable it using the command
no shutdown. The user may use the command description from
INTERFACE mode to note that the interface is the management interface. There is no separate
management routing table, so the user must configure all routes in the IP routing table (the
ip route
command).
To display the configuration for a given port, use the
show interface command from EXEC Privilege mode
(Figure 21-8).
To display the routing table for a given port, use the
show ip route command from EXEC Privilege mode.
Figure 21-8. Viewing Management Routes
FTOS#show int tengig 0/48
TenGigabitEthernet 0/48 is up, line protocol is up
Description: This is the Managment Interface
Hardware is Dell, address is 00:01:e8:cc:cc:ce
Current address is 00:01:e8:cc:cc:ce
Pluggable media not present
Interface index is 46449666
Internet address is 10.11.131.240/23
[output omitted]
FTOS#show ip route
Codes: C - connected, S - static, R - RIP,
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,
> - non-active route, + - summary route
Gateway of last resort is 10.11.131.254 to network 0.0.0.0
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
*S 0.0.0.0/0 via 10.11.131.254, Te 0/48 1/0 1d2h
C 10.11.130.0/23 Direct, Te 0/48 0/0 1d2h
FTOS#