Reference Guide

FCoE Transit | 367
Displaying FIP Snooping Information
Use the show commands in Table 16-1 to display information on FIP snooping.
Table 16-1. Displaying FIP Snooping Information
Command Output
show fip-snooping sessions [interface vlan
vlan-id]
Displays information on FIP-snooped sessions on all VLANs or a specified
VLAN, including the ENode interface and MAC address, the FCF
interface and MAC address, VLAN ID, FCoE MAC address and FCoE
session ID number (FC-ID), worldwide node name (WWNN) and the
worldwide port name (WWPN).
show fip-snooping config Displays the FIP snooping status and configured FC-MAP values.
show fip-snooping enode
[
enode-mac-address]
Displays information on the ENodes in FIP-snooped sessions, including
the ENode interface and MAC address, FCF MAC address, VLAN ID and
FC-ID.
show fip-snooping fcf [fcf-mac-address] Displays information on the FCFs in FIP-snooped sessions, including the
FCF interface and MAC address, FCF interface, VLAN ID, FC-MAP
value, FKA advertisement period, and number of ENodes connected.
clear fip-snooping database interface vlan
vlan-id {fcoe-mac-address | enode-mac-address
|
fcf-mac-address}
Clears FIP snooping information on a VLAN for a specified FCoE MAC
address, ENode MAC address, or FCF MAC address, and removes the
corresponding ACLs generated by FIP snooping.
show fip-snooping statistics [interface vlan
vlan-id| interface port-type port/slot | interface
port-channel port-channel-number]
Displays statistics on the FIP packets snooped on all interfaces, including
VLANs, physical ports, and port channels.
clear fip-snooping statistics [interface vlan
vlan-id | interface port-type port/slot | interface
port-channel port-channel-number]
Clears the statistics on the FIP packets snooped on all VLANs, a specified
VLAN, or a specified port interface.
show fip-snooping system
Displays information on the status of FIP snooping on the switch (enabled
or disabled), including the number of FCoE VLANs, FCFs, ENodes, and
currently active sessions.
show fip-snooping vlan
Displays information on the FCoE VLANs on which FIP snooping is
enabled.
Note: The show fip-snooping fcf command may continue to display FCFs advertised by S5000 Fibre
Channel ports even if the ports are shut down because the FIP snooping feature does not interpret the
A-bit in the FIP VLAN advertisements. When the S5000 is configured as an NPIV proxy gateway, use the
show interfaces status command to check if the S5000 Fibre Channel ports connected to the FCF are up
or down.