Reference Guide

Border Gateway Protocol IPv4 (BGPv4) | 255
FTOS(conf-if-te-3/11)#show config
!
interface TenGigabitEthernet 3/11
ip address 10.0.3.33/24
no shutdown
FTOS(conf-if-lo-0)#int tengig 3/21
FTOS(conf-if-te-3/21)#ip address 10.0.2.3/24
FTOS(conf-if-te-3/21)#no shutdown
FTOS(conf-if-te-3/21)#show config
!
interface TenGigabitEthernet 3/21
ip address 10.0.2.3/24
no shutdown
FTOS(conf-if-te-3/21)#
FTOS(conf-if-te-3/21)#router bgp 100
FTOS(conf-router_bgp)#show config
!
router bgp 100
FTOS(conf-router_bgp)#network 192.168.128.0/24
FTOS(conf-router_bgp)#neighbor 192.168.128.1 remote 99
FTOS(conf-router_bgp)#neighbor 192.168.128.1 no shut
FTOS(conf-router_bgp)#neighbor 192.168.128.1 update-source loop 0
FTOS(conf-router_bgp)#neighbor 192.168.128.2 remote 99
FTOS(conf-router_bgp)#neighbor 192.168.128.2 no shut
FTOS(conf-router_bgp)#neighbor 192.168.128.2 update loop 0
FTOS(conf-router_bgp)#show config
!
router bgp 100
network 192.168.128.0/24
neighbor 192.168.128.1 remote-as 99
neighbor 192.168.128.1 update-source Loopback 0
neighbor 192.168.128.1 no shutdown
neighbor 192.168.128.2 remote-as 99
neighbor 192.168.128.2 update-source Loopback 0
neighbor 192.168.128.2 no shutdown
FTOS(conf)#end
FTOS#show ip bgp summary
BGP router identifier 192.168.128.3, local AS number 100
BGP table version is 1, main routing table version 1
1 network entrie(s) using 132 bytes of memory
3 paths using 204 bytes of memory
BGP-RIB over all using 207 bytes of memory
2 BGP path attribute entrie(s) using 128 bytes of memory
2 BGP AS-PATH entrie(s) using 90 bytes of memory
2 neighbor(s) using 9216 bytes of memory
Neighbor AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/Pfx
192.168.128.1 99 24 25 1 0 0 00:14:20 1
192.168.128.2 99 14 14 1 0 0 00:10:22 1
FTOS#
Example: Enable Peer Group, Router 1
FTOS#conf
FTOS(conf)#router bgp 99