Reference Guide

Bidirectional Forwarding Detection (BFD) | 179
Figure 8-27. Establishing Sessions on Port-Channels
To establish a session on a port-channel:
View the established sessions using the command
show bfd neighbors, as shown in Figure 8-8.
Figure 8-28. Viewing Established Sessions for VLAN Neighbors
Step Task Command Syntax Command Mode
1 Establish a session on a port-channel.
bfd neighbor ip-address
INTERFACE PORT-CHANNEL
FTOS(conf-if-po-1)#bfd neighbors 2.2.2.1
FTOS(conf-if-po-1)#do show bfd neighors
* - Active session role
Ad Dn - Admin Down
C - CLI
I - ISIS
O - OSPF
R - Static Route (RTM)
V - VRRP
LocalAddr RemoteAddr Interface State Rx-int Tx-int Mult Clients
* 2.2.2.2 2.2.2.1 Po 1 Up 100 100 3 C
Port-channel BFD Sessions Enabled