Users Guide

Ranges for the CAM proles are from 1 to 10, except for the ipv6acl prole which is from 0 to 10. The
ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
If you enabled BMP, to perform a reload on the chassis to upgrade any conguration changes that have
changed the NVRAM content, use the reload conditional nvram-cfg-change command.
cam-acl-vlan
Specify the number of VFP blocks allocated to OpenFlow.
Syntax
cam-acl-vlan vlanopenflow {0|1}
Defaults Disabled.
Parameters
vlanopenow Enter the number 1 to allocate VFP blocks and enable OpenFlow.
(Default) Enter the number 0 to disable OpenFlow.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.1.(0.0) Introduced on S4810.
8.3.19.0 Introduced on the S4820T.
Usage Information
Reboot the switch after changing the parameter values for changes to take eect.
For platform-specic instructions about using this command, refer to the SDN chapter in the Dell
Networking OS Conguration Guide.
clear line
Reset a terminal line.
Syntax
clear line {line-number | console 0 | vty number}
Parameters
line-number Enter a number for one of the 12 terminal lines on the system. The range is from 0
to 11.
aux 0 Enter the keywords aux 0 to reset the auxiliary port.
98
Control and Monitoring