Users Guide

Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Related Commands
capture bgp-pdu neighbor (ipv6) – enables route reection between the route reector and the clients.
show capture bgp-pdu neighbor – congures a route reector and clients.
capture bgp-pdu neighbor (ipv6)
Enable capture of an IPv6 BGP neighbor packet.
Syntax
capture bgp-pdu neighbor ipv6-address direction {both | rx | tx}
To disable capture of the IPv6 BGP neighbor packet, use the no capture bgp-pdu neighbor
ipv6-address command.
Parameters
ipv6-address Enter the IPv6 address of the target BGP neighbor.
direction {both | rx |
tx}
Enter the keyword direction and a direction — either rx for inbound, tx for
outbound, or both.
Defaults Not congured.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Related Commands
capture bgp-pdu max-buer-size – enables route reection between the route reector and the clients.
IPv6 Border Gateway Protocol (IPv6 BGP)
973