Users Guide
Usage Information If you enter bgp dampening, the default values for half-life, reuse, suppress, and max-
suppress-time are applied. The parameters are position-dependent; therefore, if you congure one
parameter, you must congure the parameters in the order they appear in the command.
Related Commands show ip bgp ipv6 unicast dampened-paths – views the BGP paths.
bgp default local-preference
Change the default local preference value for routes exchanged between internal BGP peers.
Syntax
bgp default local-preference value
To return to the default value, use the no bgp default local-preference command.
Parameters
value Enter a number to assign to routes as the degree of preference for those routes.
When routes are compared, the higher the degree of preference or local preference
value, the more the route is preferred. The range is from 0 to 4294967295. The
default is 100.
Defaults 100
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
bgp enforce-rst-as
Disable (or enable) enforce-rst-as check for updates received from EBGP peers.
Syntax
bgp enforce-first-as
To turn o the default, use the no bgp enforce-first-as command.
Defaults Enabled.
Command Modes ROUTER BGP
IPv6 Border Gateway Protocol (IPv6 BGP)
965