Users Guide

Parameters
ip-address Enter an IP address as the route reector cluster ID.
number Enter a route reector cluster ID as a number from 1 to 4294967295.
Defaults Not congured.
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage Information
When a BGP cluster contains only one route reector, the cluster ID is the route reector’s router ID. For
redundancy, a BGP cluster may contain two or more route reectors and you assign a cluster ID with the
bgp cluster-id command. Without a cluster ID, the route reector cannot recognize route updates
from the other route reectors within the cluster.
The default format for displaying the cluster-id is dotted decimal, but if you enter the cluster-id as an integer,
it displays as an integer.
Related Commands
bgp client-to-client reection – enables route reection between the route reector and the clients.
neighbor route-reector-client – congures a route reector and clients.
show ip bgp ipv6 unicast cluster-list – views paths with a cluster ID.
bgp confederation identier
Congure an identier for a BGP confederation.
Syntax
bgp confederation identifier as-number
To delete a BGP confederation identier, use the no bgp confederation identifier as-number
command.
Parameters
as-number Enter the AS number. The range is from 1 to 65535.
Defaults Not congured.
Command Modes ROUTER BGP
962
IPv6 Border Gateway Protocol (IPv6 BGP)